Ip Mroute - D-Link DGS-6600-48TS Manual

DGS-6604

ip mroute

ip mroute SOURCE-NETWORK { RPF-ADDRESS | Null } [ DISTANCE ]
no ip mroute SOURCE-NETWORK
Syntax Description
SOURCE-NETWORK Network address of the multicast source. Format: A.B.C.D/M.
RPF-ADDRESS
Null
DISTANCE
Default
Command Mode
Usage Guideline
Examples
Switch(config)#ip mroute 192.168.6.0/24 10.1.1.1
Switch(config)#ip mroute 192.168.7.0/24 10.1.1.1 100
Switch(config)#ip mroute 192.168.8.0/24 null
CLI Reference Guide
Use this command to create a multicast static route (mroute).
Use the no form of this command to delete the route.
RPF neighbor address for the multicast route.
Indicates Null interface. When set to Null, the RPF check result will always be
failed.
(Optional) Specifies whether a unicast route or multicast static route is used for
the RPF lookup. Lower distances have preference. If the multicast static route
has the same distance as the other RPF sources, the multicast static route takes
preference. Default is 0. Range is 0-255.
DISTANCE: 0
Global configuration
This command statically configures where multicast sources are located even
when the unicast routing table shows something different.
If the RPF-ADDRESS is a PIM neighbor, PIM join, graft, and prune messages
are sent to it.
The following example configures the multicast data source within network
192.168.6.0/24 to be accessible with the neighbor router 10.1.1.1.
The following example configures the multicast data source within network
192.168.7.0/24 to be accessible with the neighbor router 10.1.1.1 and with the
distance value of 100.
The following example configures the multicast data source within a network
number 192.168.8.0/24 to be discarded.
ip mroute
281