D-Link DGS-6600-48TS Manual page 373

DGS-6604
Practical Usage
Examples
Switch > enable
Switch # configure terminal
Switch (config) # ipv6 route ::/0 vlan 1 fe80::0200:00ff:fe00:a0a0
Switch > enable
Switch # configure terminal
Switch (config) # no ipv6 route::/0 vlan 1 fe80::0200:00ff:fe00:a0a0
Configuring a
General Static
Route
Default
CLI Reference Guide
Operators may prefer to specify a default path for the managed devices. By
specifying a default gateway, traffic inside the managed topology always has the
proper path to follow. Usually, routers on smaller networks may need this
configuration, since they have less CPU computing power or less memory to
keep the entire routing table of the topology.
Imagine the topology is illustrated below. The device on the edge may not have
enough power to forward all the IPv6 traffic to the world. Therefore, it needs a
default route to serve the connected IPv6 nodes to communicate with nodes on
Internet.
This example shows how to create a default route.
After configuring the default route, the edge router will forward the unknown IPv6
traffic to the core router. By doing this, users connected to the edge router can
connect to the world (WAN/internet).
This example shows how to delete an existing default route.
To establish static IPv6 routes, use the ipv6 route command in global
configuration mode. To remove a previously configured static route, use the no
form of this command.
No static routes are configured.
ipv6 route
363