Show Ip Igmp Snooping - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ip igmp snooping

show ip igmp snooping [VLAN VLAN-ID]
Syntax Description
VLAN VLAN-ID
Default
Command Mode
Usage Guideline
Example
Switch> show ip igmp snooping
IGMP Snooping is enabled in the following VLANs
Codes- v3:IGMP v3 host compatibility mode, v2: IGMP v2 host compatibility mode
v1:IGMP v1 host compatibility mode
Vlan Querier state
----- -------------
(v3)1 Enabled
(v2)2 Disabled
(v3)3 Enabled
Total number of VLANs = 3
Switch>
CLI Reference Guide
Use this command to display IGMP Snooping information on the switch.
(Optional) Specifies a VLAN. The VLAN ID range is 1 to 4094.
If no VLAN is specified, then this command shows IGMP Snooping Information
for all VLANs where IGMP Snooping is enabled (i.e. all IGMP Snooping enabled
VLAN interfaces).
None
User EXEC or any configuration mode
The IGMP Snooping information can be displayed using this command. If the
specified VLAN does not exist or IGMP Snooping is disabled at the VLAN, an
error message will be displayed.
This example shows how to display IGMP Snooping configurations.
Querier Router
---------------
Active
-
Non-active
Immediate Timer State
Leave
--------- ------------
Enabled -
Disabled 0DT0H4M10S
Enabled 0DT0H3M12S
show ip igmp snooping
645