Loopback-Detection Mode - D-Link DGS-6600-48TS Manual

DGS-6604 m

loopback-detection mode

loopback-detection mode {port-based | vlan-based}
no loopback-detection mode
Syntax Description
port-based
vlan-based
Default
Command Mode
Usage Guideline
Example
Switch(config)# loopback-detection mode vlan-based
Switch(config)#
CLI Reference Guide
Use the command to decide the loopback detection mode. To return to the
default settings, use the no form of this command.
In port-based mode, the port will enter the error disabled state when it detects
the loop.
In VLAN-based mode, the port can't process packers of the VLAN that detects
the loop.
The default mode is port-based.
Configuration mode
If the detection mode is set to port-based means the switch determines loopback
based on port. If loop back happened, will treat the whole port as loop backed
port and block this port. LBD will send the CTP packets periodically per port.
On the other side, vlan-based mode makes switch will per port per VLAN send
the CTP packets periodically. This mode can detect loopback based on VLAN. If
switch detects loopback on a VLAN, LBD will only block the traffic which belongs
to this VLAN. Other VLANs' traffic should not be affected on this port.
This example shows how to choose the loopback detection operation mode:
You can verify your settings by entering the show loopback-detection command.
loopback-detection mode
411