Ip Ssh - D-Link DGS-6600-48TS Manual

DGS-6604

ip ssh

ip ssh [ timeout SECONDS | authentication-retries NUMBER | service-port TCP-PORT ]
no ip ssh
Syntax Description
timeout SECONDS
authentication-
retries NUMBER
service-port
TCP-PORT
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use this command to configure Secure Shell (SSH) control parameters or enable
the SSH service on the switch. Use the no ip ssh command to disable the SSH
service.
(Optional) The time interval that the switch waits for the SSH client to respond.
The range is 120-600. The SSH session will be closed when the session has
been idle for this timeout period.
(Optional) The number of authentication attempts after which the session is reset
or authentication failed. The range is 2-20.
Optional) Specifies the service port, such as TCP port 22, to which Secure Shell
(SSH) needs to connect. TCP ports are numbered between 1 and 65535.
Initial SSH service: Disabled
timeout: 120 seconds.
Maximum authentication retries: 3
service port: 22
Global configuration
The command configures Secure Shell (SSH) server parameters on the switch.
The idle timer ("timeout" option) is refreshed when the SSH client sends the
message to the server. When the idle timer expires and the SSH server does not
receive any messages from the client, the session will be released.
The SSH server can be configured with extra authentication retries for setting up
an SSH session. The connection will be failed when the number of authentication
attempts equals the maximum number of authentication attempts (retries)
allowable.
ip ssh
321