Remote-Span - D-Link DGS-6600-48TS Manual

DGS-6604 m

remote-span

remote-span
no remote-span
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth3.1
Switch(config-vlan)# trunk allowed-vlan 100
Switch(config-vlan)# exit
Switch(config)# interface eth3.5
Switch(config-vlan)# trunk allowed-vlan 100
Switch(config-vlan)# exit
Switch(config)# vlan 100
Switch(config-vlan)# remote-span
Switch(config-vlan)#exit
Switch(config)#
CLI Reference Guide
Use the command to specify a VLAN as a RSPAN VLAN. Use the no form of the
command to revert to a non RSPAN VLAN.
Not applicable
802.1q VLAN
VLAN config mode
Use the remote-span command in vlan config mode to specify a VLAN as a
RSPAN VLAN. When a VLAN is specified as a RSPAN VLAN, the access
member port of the VLAN will become inactive. The MAC address learning on
the RSPAN VLAN is disabled.
Use the command in the source switch, middle switch and the destination switch
involved in the RSPAN session.
For the middle switch involved in a RSPAN session, the port that the monitored
packet arrives from and the port that the monitored packets will be sent out need
to configured as tag member port of the RSPAN VLAN.
This example assigns VLAN 100 as the RSPAN VLAN in the middle switch of
RSPAN session. Supposed that eth3.1 is where the monitored packets arrive
and eth3.5 is where the monitored packet is transmitted.
You can verify your settings by entering the show vlan command.
remote-span
526