Max-Rcv-Frame-Size - D-Link DGS-6600-48TS Manual

DGS-6604 m

max-rcv-frame-size

max-rcv-frame-size BYTES
default max-rcv-frame-size
Syntax Description
BYTES
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# max-rcv-frame-size 6000
Switch(config-if)# end
Switch# configure terminal
Swtich(config)# interface eth4.1
Switch(config-if)# default max-rcv-frame-size
Switch(config-if)# end
CLI Reference Guide
Use the command to set the maximum Ethernet frame size allowed. Use the
default form to restore the default max-rcv-frame-size.
Set the maximum Ethernet frame size allowed. The range is 1536 to 9728 bytes.
BYTES: 1536 bytes
Interface command for physical port and port channel but not for VLAN.
Oversize frames will be dropped and the check is done within the ingress ports.
Use the command to transfer large frames or jumbo frames through the switch
system to optimize server-to-server performance.
When a port is removed from the port-channel member list, the max-rcv-frame-
size setting for the port will be reset to the default setting.
This example shows how to set max-rcv-frame-size as 6000 bytes at eth4.1
This example shows how to restore the default max-rcv-frame-size
Verify the settings by entering the show interface command.
max-rcv-frame-size
428