Show Ip Igmp Snooping Group - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ip igmp snooping group

show ip igmp snooping group [IP-ADDRESS | VLAN VLAN-ID] [detail]
Syntax Description
IP-ADDRESS
VLAN VLAN-ID
detail
Default
Command Mode
Usage Guideline
Examples
Switch# show ip igmp snooping group
IGMP Snooping Connected Group Membership: ((s)- static configuration)
Group address
-------------
224.0.1.149
224.0.1.145
224.0.2.123(s)
Total Entries : 3 entries, 6 records
Display Field
Descriptions
Field
entries
records
CLI Reference Guide
Use this command to display IGMP Snooping group information learned by the
switch.
(Optional) Specifies the Group IP address to display. If no IP address is
specified, all IGMP Snooping group information will be displayed.
(Optional) Specifies the VLAN interface to display. If no VLAN is specified, the
command shows IGMP snooping group information about all VLANs where
IGMP Snooping is enabled.
(Optional) Specifies to show the additional information (Uptime, Expires, Group
mode and Last reporter).
None
User EXEC or any configuration mode
User can display IGMP Snooping group information by this command. The
following examples cover different versions of the IGMP.
If the specified VLAN does not exist or IGMP Snooping is disabled at the VLAN,
an error message will be displayed instead.
This example shows how to display IGMP Snooping group information.
Source address
--------------- --------
10.2.2.18
10.1.1.2
10.3.3.128
show ip igmp snooping group Field Descriptions.
The number of the igmp snooping group table display.
The number of the group records and source records in the igmp snooping
group table.
Interface Port
---------
vlan1 eth3.12
vlan1 eth3.15
vlan2 eth3.1
Description
show ip igmp snooping group
647