Ip Source Binding - D-Link DGS-6600-48TS Manual

DGS-6604

ip source binding

ip source binding MAC-ADDRESS vlan VLAN-ID IP-ADDRESS interface PORT [, | -]
no ip source binding MAC-ADDRESS vlan VLAN-ID IP-ADDRESS interface PORT [, | -]
Syntax Description
MAC-ADDRESS
vlan VLAN-ID
IP-ADDRESS
PORT
,
-
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# ip source binding 00-01-02-03-04-05 vlan 2 10.1.1.1
interface eth3.10
Switch#
CLI Reference Guide
Use this command to create a static entry used for IP source guard. Use the no
form of the command to delete a static entry.
Specifies the MAC address of the IP to MAC address binding entry.
Specifies the VLAN that the valid host belongs to.
Specifies the IP address of the IP to MAC address binding entry.
Specifies the port that the valid host is connected to.
(Optional) Specify a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specify a range of interfaces. No space before and after the hyphen.
No entry is configured
Global configuration mode
Use the command to create a static binding entry used for IP source guard
check.
Use the no command to delete a static binding entry. The parameters specified
for the command must exact match the configured parameter to be deleted.
If the MAC address and the VLAN for the configured entry already exist, the
existing binding entry is updated.
The interface specified for the command can be a physical port interface.
This example shows how to configure an IP Source Guard entry with IP address
10.1.1.1 and MAC address 00-01-02-03-04-05, at VLAN 2 on interface eth3.10:
ip source binding
242