Spanning-Tree Mst Hello-Time - D-Link DGS-6600-48TS Manual

DGS-6604 m

spanning-tree mst hello-time

spanning-tree mst hello-time SECONDS
Syntax Description
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch(config)#interface eth2.1
Switch(config-if)#spanning-tree mst hello-time 1
CLI Reference Guide
Use this command to configure the per port hello time used in MSTP version.
Used to determine the time interval to send one BPDU at the designated Port.
The range is 1 to 10.
The default value for hello-time is 2.
Interface configuration
The MSTP hello-time is only referenced in MSTP mode.
Both physical ports and port-channel interfaces are valid for this command.
This example shows how to configure the port hello-time to 1 for port 2.1
Verify the settings by entering the show spanning-tree mst interface
command.
spanning-tree mst hello-time
870