Show Ddm Status - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ddm status

show ddm status [INTERFACE-ID [, | -]]
Syntax Description
INTERFACE-ID [, | -]] It is possible to specify multiple interfaces for DDM status displays. If no
Default
Command Mode
Usage Guideline
Example
Switch# show ddm status
Temperature
port (Celsius)
-------- ------------ ------------ ------------ ------------ ------------
eth2.1 23.129
eth3.25 32.539
eth3.26 31.328
CLI Reference Guide
This command displays the current operating parameters of the SFP modules.
INTERFACE-ID is specified DDM statuses on all valid interfaces are displayed.
None.
EXEC mode or any configuration mode.
It is possible to use this command to display the current operating parameters
values of the SFP module for the specified ports.
The following example shows how to display DDM statuses of all valid ports.
Voltage
(V)
3.372
3.292
3.302
Bias Current TX Power
(mA) (mW)
0.000
5.220
5.408
show ddm status
RX Power
(mW)
0.0000 0.0000
0.5300 0.0641
0.5300 0.0659
591