Erpi Tc-Propagation - D-Link DGS-6600-48TS Manual

DGS-6604 m

erpi tc-propagation

erpi INSTANCE-ID tc-propagation
no erpi INSTANCE-ID tc-propagation
Syntax Description
INSTANCE-ID
Default
Command Mode
Usage Guideline
Example
Switch(config)# erps domain 1
Switch(config-erps-domain)# erpi 2 tc-propagation
Switch(config-erps-domain)#
Switch(config)# erps domain 1
Switch(config-erps-domain)# no erpi 2 tc-propagation
Switch(config-erps-domain)#
CLI Reference Guide
Use the erpi tc-propagation command to enable topology change propagation of
the sub ERP instance. Use the no form of this command to disable topology
change propagation.
Specifies the identifier of the sub ERP instance. The valid range is 1 to 4095.
Disabled
ERPS domain configuration mode
The command setting only takes effect for the sub ERP instance.
The following example shows how to enable tc propagation state of sub ERP
instance 2 in ERPS domain 1:
The following example shows how to disable tc propagation state of sub ERP
instance 2 in ERPS domain 1:
erpi tc-propagation
204