Connecting To The Network; Additional Information - D-Link DGS-1008MP Quick Installation Manual

Attaching the Power Cord Retainer
To prevent the power from accidently being
disconnected, it is recommend to install the included
power cord retainer.
1. With the smooth side facing up, insert the tie into
the opening below the power socket.
Figure 7
2. Plug the power cord into the power socket on
the switch.
Figure 8
3. Slide the retainer through the tie until it has
reached the end of the power cord.
Figure 9
DGS-1008MP
4. Wrap the tie of the retainer strip around the
power cord and back into the retainer to lock it.
Fasten the tie until the power cord is secured.
Figure 10

Connecting to the Network

The switch can be integrated into the network
through one of the following connection methods:
Switch to End Node or Powered Device
Use a standard Ethernet cable to connect the switch
to PCs with an 10/100/1000 Mbps RJ-45 interface,
or connect and power remote IEEE 802.3af/at-
compliant devices, such as IP cameras or IP phones
using PoE.

Additional Information

For additional support, please refer to the user
manual, or visit http://support.dlink.com/ which
will direct you to your local D-Link support website.
3