Show Ip Igmp Snooping Mrouter - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ip igmp snooping mrouter

show ip igmp snooping mrouter [vlan VLAN-ID] [designate | auto | not-allowed]
Syntax Description
vlan VLAN-ID
designate
auto
not-allowed
Default
Command Mode
Usage Guideline
Example
Switch# show ip igmp snooping mrouter
vlan1
Designate : eth3.4,
Auto : eth4.2,
Not-allowed: -
vlan2
Designate : eth4.4,
Auto : eth3.2,
Not-allowed: -
Total Entries: 2
CLI Reference Guide
Use this command to display IGMP Snooping mrouter information learned and
configured on the switch.
(Optional) Specifies a VLAN. The VLAN ID range is 1 to 4094. If no VLAN is
specified, this command shows IGMP snooping information on all VLANs where
IGMP snooping is enabled.
(Optional) Display the router ports which are statically configured.
(Optional) Display the router ports which are dynamically learned.
(Optional) Display the router ports which are configured as forbidden to be router
ports.
None
User EXEC or any configuration mode
This command is used to display information on dynamically learned and
manually configured multicast router interfaces. When IGMP snooping is
enabled, the switch automatically learns the interface to which a multicast router
is connected. These are dynamically learned interfaces. If no option is specified,
all of designate, auto, and not-allowed interfaces are displayed.
When the specified VLAN does not exist or the specified VLAN is without IGMP
snooping enabled, a warning message will appear indicating this.
This example shows how to display IGMP snooping mrouter information.
show ip igmp snooping mrouter
650