Show Ip Igmp Group - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ip igmp group

show ip igmp group [IP-ADDRESS | interface INTERFACE-ID] [detail]
Syntax Description
IP-ADDRESS
interface
INTERFACE-ID
detail
Default
Command Mode
Usage Guideline
Examples
Switch#show ip igmp group interface vlan1000
Interface
-------------------------------------------------------------------
vlan1000
Total Entries : 1 entries, 2 records
Switch#
Display Field
Descriptions
Field
entries
records
CLI Reference Guide
Used to display IGMP group information on an interface
(Optional) Specifies the Group IP address to display. If no IP address is
specified, all IGMP group information will be displayed.
(Optional) Specifies the interface to display. If no interface is specified, IGMP
group information of all interfaces where IGMP is enabled will be displayed.
(Optional) Specifies to show the additional information (Uptime, Expires, Group
mode and Last reporter).
None
User EXEC or any configuration mode
User can display IGMP group information by using this command. The following
examples cover different versions of IGMP. The uptime means the time elapsed
since the entry is created. The expire time means the time that the entry will be
removed if there is no refresh of the entry,
This example shows how to display IGMP group information for interface VLAN
1000.
Group Address
224.0.1.149
show ip igmp group Field Descriptions.
The number of the igmp group table display.
The number of the group records and source records in the igmp group table.
Uptime Expires
0DT0H0M9S 0DT0H4M15S
Description
show ip igmp group
Last Reporter
10.10.0.91
641