Show Traffic-Segmentation - D-Link DGS-6600-48TS Manual

DGS-6604 m

show traffic-segmentation

show traffic-segmentation [interface INTERFACE-ID [ , | - ]]
Syntax Description
interface
INTERFACE-ID
,
-
Default
Command Mode
Usage Guideline
Example
Switch# show traffic-segmentation interface eth3.1
Interface Forwarding Interface(s)
----------------------------------------
eth3.1 eth3.1, eth3.4, eth3.5, eth3.6
Total Entries: 1
CLI Reference Guide
Use this command to show the traffic segmentation for some ports or all ports.
(Optional) Specifies the ID of an interface. The allowable interfaces are either
physical ports or port channels.
(Optional) Specifies a series of interfaces, or separate a range of interfaces from
a previous range. No space before and after the comma.
(Optional) Specifies a range of interfaces. No space before and after the hyphen.
None
User EXEC or any configuration mode
The allowable interface types for this command are either physical ports or port
channels.
If entering show traffic-segmentation without any keywords, then the traffic
segmentation configuration for all ports is displayed. Otherwise, only the
specified interface's traffic-segmentation is shown.
This example shows the configuration of traffic segmentation for eth3.1
show traffic-segmentation
771