Network (Bgp) - D-Link DGS-6600-48TS Manual

Modular layer 3 chassis ethernet managed switch
Hide thumbs Also See for DGS-6600-48TS:
Table of Contents

Advertisement

DGS-6604
m

network (BGP)

network {NETWORK-NUMBER [/SUBNET-LENGTH] | NETWORK-NUMBER [mask NETWORK-
NUMBER]} [route-map MAP-TAG]
no network {NETWORK-NUMBER [ /SUBNET-LENGTH] | NETWORK-NUMBER [mask
NETWORK-NUMBER]} [route-map MAP-TAG]
Syntax Description
NETWORK-NUMBER Specifies the number of the network that BGP will advertise.
*
SUBNET-LENGTH
mask NETWORK-
*
NUMBER
route-map MAP-TAG (Optional) Specifies the identifier of a configured route map. The route map
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65100
Switch(config-router)# network 10.108.0.0
CLI Reference Guide
Use this command to configure the networks to be advertised by the Border
Gateway Protocol (BGP) protocol. To remove an entry from the routing table, use
the no form of this command.
(Optional) Specifies the prefix length of the network or sub-network.
(Optional) Specifies the network or sub-network mask with a mask address.
should be examined to filter the networks to be advertised. If not specified, all
networks are advertised.
Specification of the sub-network can be in the form of a subnet mask or a
* Note:
stated length. It is recommended to use the subnet mask form as xxx.xxx.xxx.xxx
which is similar to Windows or Linux OS setting. However, that form will be
interchangeable between for example, 10.9.18.2/8 and 10.9.18.2 255.0.0.0.
None
Router configuration
Address family configuration
BGP networks are learned from connected routes, from dynamic routing and
from static route sources.
Use this command to specify a network as local to this autonomous system; this
will then add it to the BGP routing table. For exterior protocols, the network
command controls which networks are advertised. Interior protocols use the
network command to determine where to send updates.
When the synchronized state is enabled, BGP advertises a network entry if the
router has the route information for the entry
The following example sets up network 10.108.0.0 to be included in the BGP
updates for the AS number of 65100
network (BGP)
460

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-6600 series

Table of Contents