Router Bgp - D-Link DGS-6600-48TS Manual

DGS-6604 m

router bgp

router bgp AS-NUMBER
no router bgp AS-NUMBER
Syntax Description
AS-NUMBER
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 1.65534
Switch(config-router)#
CLI Reference Guide
Use this command to enable (configure) BGP routing process. Use the no form
of the command to remove a BGP routing process.
Specifies the number of an autonomous system that identifies the router to other
BGP routers. The range for 2-byte numbers is 1 to 65535. The range for 4-byte
numbers is 65536 to 4294967295 or 1.0 to 65535.65535.
Disabled
Global configuration
Each public autonomous system that directly connects to the Internet is assigned
a unique number that identifies both the BGP routing process and the
autonomous system (a number from 1 to 64511). Private autonomous system
numbers are in the range from 64512 to 65534 (65535 is reserved for special
use).
The AS Number size is defined as 2 bytes in RFC1771 and RFC4271.
Private autonomous system numbers can be used for internal routing domains
but must be translated for traffic that is routed out to the Internet. BGP should not
be configured to advertise private autonomous system numbers to external
networks.
Use this command to enter router configuration mode for the specified routing
process.
This example shows how to configure a BGP process for autonomous system
1.65534:
router bgp
532