Lldp Dot3-Tlv-Select - D-Link DGS-6600-48TS Manual

DGS-6604 m

lldp dot3-tlv-select

lldp dot3-tlv-select [mac-phy-cfg | link-aggregation | power | max-frame-size]
no lldp dot3-tlv-select [mac-phy-cfg | link-aggregation | power | max-frame-size]
Syntax
Description
mac-phy-cfg
link-aggregation
power
max-frame-size
CLI Reference Guide
To specify which optional type-length-value settings (TLVs) in the IEEE 802.3
Organizationally Specific TLV set will be transmitted and encapsulated in the
LLDPDUs and sent to neighbor devices, use the lldp dot3-tlv-select command
in Interface Configuration mode. To disable transmit the TLVs, use the no form of
this command.
(Optional) Specify the MAC/PHY Configuration/Status TLV to send. The
MAC/PHY Configuration/Status TLV is an optional TLV that identifies:
 The duplex and bit-rate capability of the sending IEEE 802.3 LAN node.
 The current duplex and bit-rate settings of the sending IEEE 802.3 LAN
node.
(Optional) Specify the Link Aggregation TLV to send. The Link Aggregation
TLV
indicates contains the following information:
 Whether the link is capable of being aggregated.
 Whether the link is currently in an aggregation.
The aggregated port channel ID of the port. If the port is not aggregated, then

the ID is 0.
(Optional) Specify the Power via MDI TLV to send. Three IEEE 802.3 PMD
implementations (10BASE-T, 100BASE-TX, and 1000BASE-T) allow power to
be supplied over the link for connected non-powered systems. The Power Via
MDI TLV allows network management to advertise and discover the MDI
power support capabilities of the sending IEEE 802.3 LAN station.
(Optional) Specify the Maximum Frame Size TLV to send. The Maximum
Frame Size TLV indicates the maximum frame size capability of the
implemented MAC and PHY.
When no optional keyword is selected, all supported IEEE 802.3
Organizationally Specific TLVs are selected or de-selected in no form of this
command.
lldp dot3-tlv-select
385