D-Link DGS-6600-48TS Manual page 921

DGS-6604 m
Examples
Switch# configure terminal
Switch(config)# interface eth3.1
Switch(config-if)# traffic-segmentation forward interface eth4.1-4.6
Switch(config-if)# exit
Switch# configure terminal
Switch(config)# interface eth3.1
Switch(config-if)# no traffic-segmentation forward interface eth4.2-4.3
Switch(config-if)# exit
CLI Reference Guide
When entering no traffic-segmentation without any keywords, then all ports will
become the forwarding port. When entering no traffic-segmentation forward
without the interface keyword, then all ports in forwarding port list will be
removed. That is, the forwarding domain of the configured interface is empty.
This example shows how to configure traffic segmentation. It restricts the
flooding domain of eth3.1 to a set of ports, which are eth4.1 - 4.6.
This example shows how to remove some ports eth4.2- 4.3 from the forwarding
port list.
Verify the settings by entering the show traffic-segmentation command.
traffic-segmentation forward
911