Address-Family Ipv - D-Link DGS-6600-48TS Manual

DGS-6604 m

address-family ipv4

address-family ipv4 [unicast ]
no address-family ipv4 [unicast]
Syntax Description
unicast
Default
Command Mode
Usage Guideline
Example
Switch(config)# router bgp 65100
Switch(config-router)# address-family ipv4
Switch(config-router-af)# exit
Switch(config-router)#
CLI Reference Guide
Use this command to enter address family configuration mode to configure a
routing session using standard IP Version 4 address prefixes. Use the no form of
this command to remove the IPv4 address family configuration from the running
configuration.
(Optional) Specifies IP Version 4 unicast address prefixes.
Unicast prefix support is enabled by default when this command is entered
without any optional keywords.
Router configuration
Routing information for address family IPv4 unicast is advertised by default for
each BGP routing session configured with the neighbor remote-as command
unless the no bgp default ipv4-unicast command is used before configuring the
neighbor remote-as command.
For all settings configured for IPv4 unicast, the settings also appear in BGP
router configuration mode. That is, for address-family associated settings, the
settings defined in IPv4 unicast address family mode is equivalent to the settings
defined in the router configuration mode.
To leave address family configuration mode and return to router configuration
mode without removing the existing configuration, enter the exit command.
This example shows how to enter address family configuration mode for the IP
Version 4 address family:
address-family ipv4
37