Vlan Access Vlan - D-Link DGS-6600-48TS Manual

DGS-6604 m
access vlan
access vlan VLAN-ID
default access vlan
Syntax Description
access vlan
VLAN-ID
Default
Command Mode
Usage Guideline
Examples
Switch(config)# interface eth3.1
Switch(config-if)# access vlan 1000
CLI Reference Guide
Use the access vlan interface configuration command to specify the access
VLAN for the interface. Use default interface vlan command to reset to default
setting.
Specifies the access VLAN for the interface.
VLAN 1
Interface configuration
The command is valid for physical ports or port-channel interfaces. If the VLAN
does not exist, the VLAN will be automatically created and a message prompt will
appear. By default, the port has access VLAN 1.
The following applies to access VLANs:
• An interface can be specified with only one access VLAN. The succeed-
ing command overwrites the previous command.
• When this command is applied, the port will change to Access mode. If
the port has been configured for other modes, Access mode will overwrite
the previous mode. The port's PVID is changed to the specified VLAN.
This example shows how to set an interface eth3.1 to an untagged member of
VLAN 1000.
Verify the settings by entering the show vlan interface command.
access vlan
36