Show Ipv6 Rip Interface - D-Link DGS-6600-48TS Manual

DGS-6604 m

show ipv6 rip interface

show ipv6 rip interface [IFNAME]
Syntax Description
IFNAME
Default
Command Mode
Privileged EXEC
mode
Example
Switch > enable
Switch # show ipv6 rip interface vlan1
vlan1 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IPv6 interface address:
fe80::a01:2ff:fe36:1/64
CLI Reference Guide
To display the usability status of interfaces configured for IPv6 RIP, use the show
ipv6 rip interface command.
The specified interface type and interface number
None
User EXEC
Usage Guideline
Use the show ipv6 rip interface command to validate the IPv6 RIP status of an
interface and its configured addresses. The show ipv6 rip interface command
also displays the parameters that IPv6 RIP is using on this interface including
any configured features.
If the argument IFNAME is not used then all IPv6 RIP interfaces are displayed.
The following is sample output in vlan1 from the show ipv6 rip interface
command.
show ipv6 rip interface
720