Erpi Ring-Port - D-Link DGS-6600-48TS Manual

DGS-6604 m

erpi ring-port

erpi INSTANCE-ID ring-port {east | west} {shared | INTERFACE-ID}
no erpi INSTANCE-ID ring-port {east | west | shared}
Syntax Description
INTERFACE-ID
east
west
shared
INTERFACE-ID
Default
Command Mode
Usage Guideline
Example
Switch(config-erps-domain)# erpi 1 ring-port east eth3.1
Switch(config-erps-domain)#
Switch(config-erps-domain)# erpi 1 ring-port west eth3.2
Switch(config-erps-domain)#
Switch(config-erps-domain)# erpi 1 ring-port east port-channel1
Switch(config-erps-domain)#
CLI Reference Guide
Use the erpi ring-port command to configure the ring ports of an ERP instance.
Use the no form of this command to remove the ring port setting.
Specifies the identifier of the ERP instance. The valid range is 1 to 4095.
Specifies the port as the east ring port.
Specifies the port as the west ring port.
Specifies the port as a shared ring port for the sub ERP instance.
Specifies the interface of configured ring port, it can be a physical port or a port-
channel interface.
Not configured
ERPS domain configuration mode
Use the command to configure the ring ports for the ERP instance. For each ERP
instance, two ring ports, east ring port and west ring port need to be configured.
The ring port should be configured as the tag member ports of the R-APS
controlled VLAN.
The following example shows how to configure interface "eth3.1" as the east ring
port of ERP instance 1:
The following example shows how to configure interface "eth3.2" as the west ring
port of ERP instance 1:
The following example shows how to configure interface "port-channel1" as the
east ring port of ERP instance 1:
erpi ring-port
197