D-Link DGS-6600-48TS Manual page 490

DGS-6604 m
ping
ping [OPTIONS] {IP-ADDRESS | IPV6-ADDRESS}
Syntax Description
OPTIONS
IP-ADDRESS
IPV6-ADDRESS
Default
CLI Reference Guide
Use ping to diagnose basic network connectivity.
(Optional) The option can be any combination of the following parameters:
-A
Adapt to return interval of packets. That is to send packets at approximately the
rate at which they are received.
-c COUNT
Stop after sending count ECHO_RESPONSE packets.
-i WAIT
Wait WAIT seconds between sending each packet. Default is to wait one second
between each packet. This option is incompatible with -A option and it will be
ignored when it is along with -A option.
-Q TOS
Set Quality of Service on ICMP data grams.
-s PACKETSIZE
Specifies the number of data bytes to be sent. Default is 56, which translates into
64 ICMP data bytes when combined with the 8 bytes of ICMP header data. It
does not include any VLAN or IEEE802.1Q tag length.
-w N
Stop ping after N seconds.
-W N
When waiting for a response, time out after N seconds. If N is not specified, the
default is one second.
IPv4 address in dot notation (a.b.c.d) of the destination host.
IPv6 address of the destination host.
-s: 56 bytes
-c: 5 count packets
-i: 1 second
-Q: 0 TOS
ping
480