Spanning-Tree Cost - D-Link DGS-6600-48TS Manual

DGS-6604 m

spanning-tree cost

spanning-tree cost COST
no spanning-tree cost
Syntax Description
COST
Default
Command Mode
Usage Guideline
Example
Switch(config)#interface eth3.7
Switch(config-if)#spanning-tree cost 20000
CLI Reference Guide
This setting is used to configure the value of port path-cost on the specified port.
Specifies the path cost for the port. The range is 1 to 200000000.
The path cost is computed from the bandwidth setting of the interface.
Interface configuration
Both physical port and port-channel interfaces are valid for this command,.
In RSTP / STP-Compatible mode, the administrative path cost is used by the
single spanning-tree when accumulating the path cost to reach the Root.
In MSTP mode, the administrative path cost is used by the CIST regional root
when accumulating the path cost to reach the CIST root.
This example shows how to configure the port cost to 20000 for eth3.7.
Verify the settings by entering the show spanning-tree interface command.
spanning-tree cost
862