Qos Cos - D-Link DGS-6600-48TS Manual

DGS-6604 m

qos cos

qos cos COS-VALUE
Syntax Description
COS-VALUE
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface
switch(config-if)# qos cos 3
CLI Reference Guide
To configure the default class of service (CoS) value of a port, use the qos cos
command in interface configuration mode.
Assigns a default CoS value to a port. This CoS will be with the incoming CoS of
the un-tagged packet received by the port.
COS-VALUE: 0
Interface configuration
Only physical ports are valid.
In the following example, default COS of eth3.1 is set to 3.
eth3.1
Verify the settings by entering the show qos interface cos command.
qos cos
506