Ip Pim Accept-Register - D-Link DGS-6600-48TS Manual

DGS-6604

ip pim accept-register

ip pim accept-register source-list ACCESS-LIST-NAME
no ip pim accept-register
Syntax Description
source-list ACCESS-
LIST-NAME
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# ip access-list Summer-Movie
Switch(config-ip-acl)# deny any 232.0.0.0 255.0.0.0
Switch(config-ip-acl)# permit any any
Switch(config-ip-acl)# exit
Switch(config)# ip pim accept-register source-list Summer-Movie
CLI Reference Guide
To configure a candidate rendezvous point (RP) router to filter PIM register
messages, use the ip pim accept-register command in global configuration
mode. To disable this function, use the no form of this command.
Specifies the name of the basic IP access list name.
Disabled
Global configuration
This command can be only specified once. The later applied command will
override the previous setting.
Use this command to prevent unauthorized sources from registering with the RP.
If an unauthorized source sends a register message to the RP, the RP will
immediately send back a register-stop message.
The following example shows how to restrict the RP from allowing sources in the
Source Specific Multicast (SSM) range of addresses to register with the RP.
These statements need to be configured only on the RP.
Verify the settings by the show ip pim command.
ip pim accept-register
298