Table of Contents
Advertisement
5.1 Hot plug procedure
5.1.1 Redundant power module
The redundant power modules of E
the two power modules or a power net is failing, you can hear a buzzer alarm that can be reset by pushing the
red buzzer reset button [5] / [2] at the front of E
Extender. Also the LED power module failed [6] / [4] at the front lightens up. This LED stays lightened as long as
the failure persists even if the buzzer reset button was pressed.
14
air supply
25
mains connection
35
power switch
36
green LED: power module operating
37
securing screw
38
handle
The defective power module or the failing power net can be located by examining the individual LED's power
module operating [36] on the back of E
it is switched on, the module is either defective and must be re-placed or the power net connected to it has
failed.
Barco – Eos X Terminal – DOC-3061-2 – user's manual – Revision 11 – November-2004
or E
E
can be connected to two independent power nets. If one of
OS
OS
XTENDER
/ E
OS
OS
37
25
38
35
Power module on the rear of E
/ E
E
. If the green LED on a power module is off even though
OS
OS
XTENDER
E
, please refer to section
XTENDER
14
14
36
or E
OS
_____________________________________________________________________
5. Maintenance
3.1.1 Eos
/
3.1.2 Eos
Figure 5-1
E
for redundant operation
OS
XTENDER
5-3
Advertisement
Table of Contents
