Dot1X Timeout Tx-Period - Planet WGSD-1022 User Manual

unreliable links or specific behavioral problems with certain clients and authentication servers.
If it is necessary to provide a faster response time to the user, a smaller number than the default should
be entered.
Examples
The following example sets the number of seconds that the switch remains in the quiet state following a
failed authentication exchange, to 3600.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout quiet-period 3600

5.29.8 dot1x timeout tx-period

The dot1x timeout tx-period interface configuration command sets the number of seconds that the
switch waits for a response to an Extensible Authentication Protocol (EAP) - request/identity frame, from
the client, before resending the request. Use the no form of this command to return to the default setting.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds — Time in seconds that the switch should wait for a response to an EAP -request/identity
frame from the client before resending the request. (Range: 1 - 65535 seconds)
Default Configuration
30
Command Mode
Interface configuration (Ethernet)
Examples
The following command sets the number of seconds that the switch waits for a response to an EAP -
request/identity frame, to 3600 seconds.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout tx-period 3600