Spanning-Tree Priority - Planet WGSD-1022 User Manual

Command Modes
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the spanning-tree bridge maximum-age to 10 seconds.
Console(config)# spanning-tree max-age 10

5.21.6 spanning-tree priority

The spanning-tree priority global configuration command configures the spanning-tree priority. The
priority value is used to determine which bridge is elected as the root bridge. To reset the default
spanning-tree priority use the no form of this command.
Syntax
spanning-tree priority priority
no spanning-tree priority
priority — Priority of the bridge. (Range: 0 - 61440 in steps of 4096)
Default Configuration
The default bridge priority for IEEE STP is 32768.
Command Modes
Global Configuration mode
User Guidelines
The lower the priority, the more likely the bridge is to be the Root Bridge.
Example
The following example configures spanning-tree priority to 12288.
Console(config)# spanning-tree priority 12288