Table of Contents
Advertisement
Example
The following example globally enables GVRP on the device.
Console (config)# gvrp enable
5.8.2 gvrp enable (interface)
The gvrp enable interface configuration command enables GVRP on an interface. To disable GVRP on
an interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces by default.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
An access port would not dynamically join a VLAN because it is always a member in only one VLAN.
Example
The following example enables GVRP on ethernet g8.
Console (config)# interface ethernet e8
Console (config-if)# gvrp enable
5.8.3 garp timer
The garp timer interface configuration command adjusts the GARP application join, leave, and leaveall
GARP timer values. To reset the timer to default values, use the no form of this command.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer
join — Indicates the time in milliseconds that PDUs are transmitted. (Range: 10-2147483640)
leave — Indicates the amount of time in milliseconds that the device waits before leaving its
Advertisement
Table of Contents
