Dot1X Re-Authenticate; Dot1X Re-Authentication; Dot1X System-Auth-Control; Dot1X Timeout - Planet WGSW-24000 User Manual

▫
Mode Global Config

10.1.10 dot1x re-authenticate

This command begins the re-authentication sequence on the specified port. This command is only valid if
the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
▫
Format dot1x re-authenticate <slot/port>
▫
Mode Privileged EXEC

10.1.11 dot1x re-authentication

This command enables re-authentication of the supplicant for the specified port.
▫
Default Disabled
▫
Format dot1x re-authentication
▫
Mode Interface Config
10.1.11.1 no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
▫
Format no dot1x re-authentication
▫
Mode Interface Config

10.1.12 dot1x system-auth-control

This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
▫
Default Disabled
▫
Format dot1x system-auth-control
▫
Mode Global Config
10.1.12.1 no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
▫
Format no dot1x system-auth-control
▫
Mode Global Config

10.1.13 dot1x timeout

▫ This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set. The following tokens are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state machine on
this port to determine when re-authentication of the supplicant takes place. The reauth-period must