5.4.2 bridge multicast filtering
The bridge multicast filtering global configuration command enables filtering of multicast addresses
disable filtering of multicast addresses, use the no form of the bridge multicast filtering command.
Syntax
bridge multic
ast filtering
no b
ridge multicast filtering
Default Configuration
Disab
led. All multicast addres
Co
mmand Mode
Glob
al Configuration mode
User Guidelines
If multicast routers exist on the
forward-all command sh
Example
I
n this example, bridge multicast filtering is enabled.
console (config)# bridge multicast filtering
5.4.3 bridge multicast address
The bridge multicast address interface configuration command registers MAC-layer multicast
addresses t
o the bridge table, and adds static ports to the group. To unregister the MAC address, use the
no form of the bridge multicast address command.
Syntax
bridge multicast address {mac-multicast-
brid e
g multicast address {mac-multicast-address | ip-m
interface-list | port-channel port-channel-number-list}
no bridge multicast address {mac-multicast-address | ip-multicast-address}
add — Adds ports to the group
remove — Removes ports
mac-multicast-address — MAC multicast address.
ip- multicast-address — IP multicast address.
ses are flooded to all ports of the relevant VLAN.
VLAN and IGMP-snooping is not enabled, the bridge multicast
ould be used to enable forwarding all multicast packets to the multicast routers.
address | ip-multicast-address}
. If no option is specified, this is the default option.
from the group.
ulticast-address} [add | remove] {ethernet
. To