Enable Password; Username - Planet WGSD-1022 User Manual

5.3.9 enable password

The enable password global configuration command sets a local password to control access to normal
and privilege levels. To remove the password requirement, use the no form of this command.
Syntax
enable passw ord [level level] password [encrypted]
no enable password [level level]
password — Password for this level, from 1 to 159 characters in length.
level level — Level for which the p
encrypted — Encrypted password entered, copied from another device configuration.
De a f ult Configuration
Thi s c mmand has no default configuration. o
Comman d Mode
Global Configuration mode
User Guidelines
There are no user guidelines
Example
The following example sets a local l
console (config-line) # enable password level 15 abc

5.3.10 username

T he username global configuration comma
re move a user name use the no form of this command.
Syntax
username name [password password
no username
name — The name of the user.
passw ord — The authentication password for the user, from 1 to 159 characters in length.
level — The us er level (Range: 1 -15).
encrypted — Encrypted password entered, copied from another device configuration.
D efault Configuration
The default privilege level is 1.
assword applies. If not specified the level is 15 (Range: 1-15).
for this command.
evel 15 password "abc" to control access to user and privilege levels.
nd establishes a username-based authentication system. To
] [privilege level] [encrypted]