Ip Igmp Snooping Mrouter-Time-Out - Planet WGSD-1022 User Manual

User Guidelines
The timeout should be at least greater than 2*query_interval+max_response_time of the IGMP router.
Example
The following example configures the host timeout to 300 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping host-time-out 300

5.9.5 ip igmp snooping mrouter-time-out

The ip igmp snooping mrouter-time-out interface configuration command configures the
mrouter-time-out. The mrouter-time-out command is used for setting the aging-out time after multicast
router ports are automatically learned. To configure the default mrouter-time-out, use the no form of this
command.
Syntax
ip igmp snooping mrouter-time-out time-out
no ip igmp snooping mrouter-time-out
time-out—mrouter timeout in seconds (Range: 1 - 2147483647)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the mrouter timeout to 200 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping mrouter-time-out 200