Table of Contents
Advertisement
Syntax
switchport trunk native vlan vlan-id
no switchport trunk native vlan
vlan-id — Valid VLAN ID of the active VLAN.
Default Configuration
VLAN ID=1
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has the following consequences: incoming untagged frames are assigned to this VLAN
and outgoing traffic in this VLAN on this port is sent untagged (despite the normal situation where traffic
sent from a trunkmode port is all tagged).
The command adds the port as a member in the VLAN. If the port is already a member in the VLAN (not
as a native), it should be first removed from the VLAN.
Example
The following example e8, in trunk mode, is configured to use VLAN number 123 as the "native" VLAN.
Console (config)# interface ethernet e8
Console (config-if)# switchport trunk native vlan 123
5.27.11 switchport general allowed vlan
The switchport general allowed vlan interface configuration command adds or removes VLANs from a
general port.
Syntax
switchport general allowed vlan add vlan-list [ tagged | untagged ]
switchport general allowed vlan remove vlan-list
add vlan-list — List of VLAN IDs to add. Separate non consecutive VLAN IDs with a comma and
no spaces. A hyphen designates a range of IDs.
remove vlan-list — List of VLAN IDs to remove. Separate non consecutive VLAN IDs with a
comma and no spaces. A hyphen designates a range of IDs.
Advertisement
Table of Contents
