Show Interfaces Configuration - Planet WGSD-1022 User Manual

console# set interface active ethernet e5

5.7.14 show interfaces configuration

The show interfaces configuration Privilege EXEC mode command displays the configuration for all
configured interfaces.
Syntax
show interfaces configuration [ethernet interface | port-channel port-channel-number | ]
Interface — Valid Ethernet port.
port-channel-number — Valid port-channel trunk index.
oob-interface — Out-of-band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Modes
Privilege EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration for all configured interfaces:
console# show interfaces configuration
Port Type
-------- ------------
e1 100M-Copper Full
e2 100M-Copper Full
e3 100M-Copper Full
e4 100M-Copper Full
e5 100M-Copper Full
e6 100M-Copper Full
e7 100M-Copper Full
e8 100M-Copper Full
g1 1G-Combo-C Full
g2 1G-Combo-C Full
Ch Type Speed Neg control
-------- ------- ----- --------
ch1 -- --
ch2 -- --
Duplex Speed Neg
------ ----- --------
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
100 Enabled Off
1000 Enabled Off
1000 Enabled Off
Flow Admin
State
------- -----
Enabled Off Up
Enabled Off Up
Flow Admin Back
control State Pressure Mode
------- ----- -------- ----
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Up Disabled Auto
Mdix