Table of Contents
Advertisement
Configuration mode command interface port-channel is used to enter the port-channel Interf
Configuration mode.
SSH Public Key-chain—Contains commands to manually specify other device SSH public keys.
The Global Configuration mode command crypto key pubkey-ch
SSH Public Key-chain Configur
MAC Access-List—Configures
Global Configuration mo
configuration mode.
Interface—Contains commands that configure the interface. The Global Configuration mode
command interface e
5.2.2 Starting the CLI
The switch can be managed over a direct connection to the switch console port, or via a Te
connection. The switch can also be managed via an out-of-band (OOB) management port. The switch is
managed by entering command keywords and parameters at the prompt. Using the switch command-line
interface (C
LI) is very similar to entering commands on a UNIX sy
If access is via a Telnet connection, ensure that the device has an IP address defined, that corresponding
mana
gement access is granted, and that the workstation used to access the device is connected to the
devic
e prior to beginning using CLI commands.
Note: The following steps are for use on the console line only.
To begin running CLI, perform the following:
1. Start the device and wait u
2. The User Exec mode is entered into, and the prompt "console>" is displayed.
3. C
onfigure the device and enter the necessary commands to complete the
4. W
hen finished, exit the session with the quit or exit command.
When a dif
ferent user is required to log onto the system, in the Privileged EXEC Command mode the
login command is entere
ation mode.
conditions required to allow traffic based on MAC addresses. The
de command mac-access list is used to enter the MAC access-list
thernet is used to enter the interface configuration mode.
ntil the startup procedure is complete.
d. This effectively logs off the current user and logs on the new user.
ain ssh is used to enter the
stem.
required tasks.
ace
lnet
Advertisement
Table of Contents
