Show Interfaces Status - Planet WGSD-1022 User Manual

ch3 -- --
ch4 -- --
ch5 -- --
ch6 -- --
ch7 -- --
ch8 -- --
The displayed port configuration information includes the following:
Port—The port number.
Port Type—The port designated IEEE shorthand identifier. For example 1000Base-T refers to
1000 Mbps baseband signaling inluding both Tx and Rx transmissions.
Duplex—Displays the port Duplex status.
Speed—Refers to the port speed.
Neg—Describes the Auto-negotiation status.
Flow Control—Displays the Flow Control status.
Back Pressure—Displays the Back Pressure status.
MDIX Mode—Displays the Auto-crossover status.
Admin State—Displays whether the port is enabled or disabled.

5.7.15 show interfaces status

The show interfaces status user EXEC command displays the status for all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number | out-of-band-eth
oob-interface]
Interface — A valid Ethernet port.
port-channel-number — A valid port-channel trunk index.
oob-interface — Out of band Ethernet port number.
Default Configuration
This command has no default configuration.
Command Mode
Privilege EXEC mode
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up
Enabled Off Up