Installing The Sfp Transceiver - Planet WGSD-1022 User Manual

2.2.3 Installing the SFP transceiver

The sections describe how to insert an SFP transceiv
The SFP transceivers are hot-plug e and hot-swappable. You can plug-in and out the transceiver to/from
any SFP port without having to power down the Switch. As the Figure 2-7 appears.
Approved PLANET SFP Transceivers
PLANET WGSD-1022 support both single mode and multi mode SFP
approved PLANET SFP transceivers is correct at the time of publication:
SFP (1000BASE-SX SFP transceiver )
■MGB-SX
MGB-LX SFP (1000BASE-LX SFP
■
It recommends using PLANET SFPs on the Switc
Note
:
that is not supported, the Switch will not recognize it.
Before connect the other switches, workstation or Media Converter.
1 . Make sure b oth side of the
1000Ba se-S X, 1000Bas-LX to 1000Base-LX.
2. Check the fi ber-optic cable
To connect to
be mal e duplex LC connector type.
To con nect to 100
must be male duplex LC connector type.
Connect the fib er cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
Figu re 2-7 Plug-in the SFP transceiver
transceiver )
SFP transfer are with the same
type match the SFP transfer m
1000Base-SX SFP transfer, use the
0Base-LX SFP transfer, use the single-mode fiber cable-with one side
er into an SFP slot.
transceiver. The following list of
h. If you insert a SFP transceiver
media type, for examp
odel.
multi-mode fiber cable- with one side
le: 1000Base-SX to
must