Table of Contents
Advertisement
Console# show ports jumbo-frame
Jumbo frames are disabled
Jumbo frames will be enabled after reset
5.7.20 port storm-control broadcast enable
The port storm-control broadcast enable interface configuration command enables broadcast storm
control. To disable broadcast storm control, use the no form of this command.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate interface configuration command, to set the maximum
allowable broadcast rate.
Multicast can be counted as part of the "storm" frames if the port storm-control include-multicast
global configuration command is already executed.
Example
The following example enables broadcast storm control on port e5.
Console(config)# interface ethernet e5
Console(config-if)# port storm-control broadcast enable
5.7.21 port storm-control broadcast rate
The port storm-control broadcast rate interface configuration command configures the maximum
broadcast rate. Use the no form of this command to configure the default value.
Advertisement
Table of Contents
