Dot1X Timeout Tx-Period; Dot1X Max-Req - Planet WGSD-1022 User Manual

exchange, to 3600.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout quiet-period 3600

5.29.8 dot1x timeout tx-period

The dot1x timeout tx-period interface configuration command sets the number of seconds that the switch waits for a response
to an Extensible Authentication Protocol (EAP) - request/identity frame, from the client, before resending the request. Use the
no form of this command to return to the default setting.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds — Time in seconds that the switch should wait for a response to an EAP -request/identity frame from the client
before resending the request. (Range: 1 - 65535 seconds)
Default Configuration
30
Command Mode
Interface configuration (Ethernet)
Examples
The following command sets the number of seconds that the switch waits for a response to an EAP - request/identity frame, to
3600 seconds.
Console (config)# interface ethernet e8
Console (config-if)# dot1x timeout tx-period 3600

5.29.9 dot1x max-req

The dot1x max-req interface configuration command sets the maximum number of times that the switch sends an Extensible
Authentication Protocol (EAP) - request/identity frame (assuming that no response is received) to the client, before restarting
the authentication process. Use the no form of this command to return to the default setting.
User's Manual of WGSD-1022/WGSD-8000
- 368 –