Dot1X Timeout Re-Authperiod - Planet SGSD-1022 User Manual

no dot1x timeout quiet-period
seconds -The number of seconds. (Range: 1-65535)
Default
60 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout quiet-period 350
Console(config-if)#

dot1x timeout re-authperiod

This command sets the time period after which a connected client must be re-authenticated.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
seconds -The number of seconds. (Range: 1-65535)
Default
3600 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
dot1x timeout tx-period
This command sets the time that an interface on the switch waits during an authentication session before re-transmitting an EAP
packet. Use the no form to reset to the default value.
Syntax
dot1x timeout tx-period seconds
User's Manual of SGSD-1022 / SGSD-1022P
464
SGSW-2840 / SGSW-2840P