Table of Contents
Advertisement
10—Configures the port to 10 Mbps.
100—Configures the port to 100 Mbps.
1000—Configures the port to 1000 Mbps.
Default Configuration
Maximum port capability.
Command Mode
Interface Configuration (Ethernet, port-channel, out-of-band Ethernet) mode
User Guidelines
The command "no speed" in port-channel context returns each port in the port-channel to its maximum
capability.
Before attempting to force a particular duplex mode the port operating at 10/100 Mbps, disable the
auto-negotiation on that port.
Example
The following example configures the speed operation of Ethernet e5 to force 100-Mbps operation.
Console(config)# interface ethernet e5
Console(config-if)# speed 100
5.7.6 duplex
The duplex interface configuration command configures the full/half duplex operation of a given Ethernet
interface when not using auto-negotiation. To restore the default, use the no form of this command.
Syntax
duplex {half | full}
no duplex
half—Force half-duplex operation
full—Force full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet, out-of-band Ethernet) mode
Advertisement
Table of Contents
