Accessing Spm; Remote Modem Connection - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
2 Programming with SPM

Accessing SPM

Public or private
telephone network
Figure 2–4.

Remote Modem Connection

NOTE: NOTE: NOTE:
Remote access (modem connection) has priority over local access (direct
connection), unless a backup or restore procedure is in progress through a
direct local connection. If a modem connection is attempted while any other
type of on-site programming is in progress (either at the system or at a
directly-connected PC), the system sends a message to the on-site
programmer. The message indicates that a modem connection is being
established and the on-site programming session is terminated.
Accessing SPM
The procedure for accessing SPM depends on whether your PC is connected to
the control unit with a modem (either local or remote) or without a modem (direct).
This section covers both of these access procedures.
With a Direct Local Connection
To access SPM when your PC is connected directly to the control unit, follow the
steps below.
Serial
Communications
Port
RS-232
MODEM
Incoming
trunk line
Tu rn
po we off
ins ert r be
for e
rem ing or
mo du ovi ng
les
AG INPUT
2
2
Issue 1
February 1998
Page 2-16