Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 476

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
4 Programming Procedures
Basic System Operating Conditions
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure More
PC Procedure
Board Renumbering
! !
CAUTION: CAUTION:
This procedure is to be performed by qualified support personnel only.
Use this procedure to renumber boards that have already been installed. This
procedure restarts the system (system programming is not lost). Note that this is
not the same procedure used with the Boards option, which is available to
qualified service personnel with SPM only.
Board Renumber is a system programming procedure that is required only when
an existing module is replaced by a different type of module. When a Board
Renumber is performed, the system reassigns the logical ID numbers to the
extension and line ports sequentially from left to right in the control unit and from
bottom to top of each module.
Summary: Board Renumbering
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
English
English, French, Spanish
No
No
 È Ã Å
Select a language
Qualified support personnel only
All
System idle
Not applicable
None
Not applicable
Not applicable
Not applicable
Ã Æ Ä
Select a language
4
4
Issue 1
February 1998
Page 4-6