Installing The Spm Software - Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
2 Programming with SPM

Installing the SPM Software

Installation
With Windows 95 running on your PC, follow these steps to install SPM on the
PC's hard drive:
1. Insert a backup copy of SPM in any floppy disk drive (usually the A drive).
2. Choose one of the following two methods to install SPM:
Method 1– Install DOS SPM with French, Spanish, or English
Language:
a.
b.
c.
Method 2– Install DOS SPM with French, Spanish, or English
Language:
a.
b.
3. After you start DOS SPM installation using either method, the following
message appears:
4. Press any key to begin the installation.
Open a DOS Window from Windows Explorer.
At the DOS prompt, switch to the drive with the backup copy of SPM
diskette (usually the A drive).
At the DOS prompt, type one of the commands shown below and
press .
NOTE:
Because English is the factory-set language,
JOTUBM  FOHMJTI
have the same result. If you do use the language
argument ( ,
lowercase letters as shown. The command
uppercase or lowercase letters.
From the Windows Explorer, select the floppy drive that contains the
backup copy of SPM diskette.
Select and run Instal95 (either by double clicking on the file name or
single clicking on the file name and using the menu choice
File:Open).
2
JOTUBM 
or ), you must type it in
JOTUBM 
Issue 1
February 1998
Page 2-7
and
may be in