Lucent Technologies MERLIN LEGEND Release 6.0 System Programming Manual page 43

MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
1 Programming Basics
Programming Procedures
Table 1–2.
Display
Using Enter
Pressing
The next screen in the procedure appears. See Steps 4 and 5 in the
sample procedure below.
The screen does not change and you can enter another extension or line/
trunk. In most of these cases,
to assign the extension to a group or to assign a feature to the extension.
feature from the extension. See Steps 5 and 6 in the sample procedure
below for an example of this type of screen.
The procedure is complete and you return to a previous screen.
Screen Keys (Continued)

Key Function
Program sequentially numbered items. If you are
programming a group of sequentially numbered
extensions, lines, or trunks, you may have the option
to select
and automatically provides the number of the next
extension or trunk in the sequence. Typically, you
remain at the same screen until you select
a few cases, you may return to an earlier screen in
Ç
the procedure.
Return to the previous screen. Select
the PC) when you complete a procedure, to move up
one screen in the menu hierarchy. (Appendix B
provides a reference to the entire System
Programming menu hierarchy.)
Exit a screen without changes. In most cases, you
select
without making any changes. Exceptions are noted
as part of a procedure.
Complete a procedure. In a few cases, you return
to the System Programming menu when you select
. In most cases, you return to an intermediate
step within the procedure. You can then select one of
the options shown on the screen and continue
programming, or you can continue to use Exit until
you return to the System Programming menu.
to save your entry has one of the following results:
is used to remove the extension from a group or to remove the

( on the PC). This saves your entry
Ç
( on the PC) to exit from a screen
1
is also an option.
Issue 1
February 1998
Page 1-21
. In
Ç
( on
is used either