MERLIN LEGEND Communications System Release 6.0
System Programming 555-660-111
3
Common Administrative Procedures
Optional Group Features
Console/Display Instructions
Save your entry.
!
Select
.
Return to the System Programming menu.
!
Select
.
Group Calling Member Assignments
Use this procedure to assign or remove an extension to or from a calling group. A
calling group is used to direct calls to a group of people who all handle the same
type of call. A single extension number is assigned to the group and is used by
both inside and outside callers to reach the group.
To reassign an extension to a new calling group, you must remove it from its old
group before programming the new assignment.
NOTES:
1. If a linear hunting pattern is indicated on the back of the system planning
2. A maximum of 32 calling groups with a maximum of 20 extensions per
3. An extension can belong to only one calling group. A QCC cannot be a
4. The extension status feature must be set to the Calling Group or CMS
Summary: Group Calling Member Assignments
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
form (6d), be sure to assign extensions to the group in the exact order
that they are shown on the form. The system searches for an available
member in the order in which you assign the extensions to the group.
group is allowed.
member of a calling group. A delay announcement device should not be
programmed as a calling group member.
mode before you assign members to the group. See
on page 208.
System Manager
All
Not required
Form 7c, Group Coverage
Not applicable
Extension numbers
Additional Information
3
3
Issue 1
February 1998
Page 3-150
PC
Ç
"Extension Status"
Need help?
Do you have a question about the MERLIN LEGEND Release 6.0 and is the answer not in the manual?